Set up MDM message - Data to staging

To send data from a source company to a staging journal, you need two connectors, two documents, and a message.

To set up these components for MDM studio, some specific setup is required:

Component	Description
Source connector	Use a source connector of type 'D365 F&SCM'.
Target connector	Use a target connector of type 'Staging journal'. Make sure the 'BisConnectorStagingJournal' handler class is used.
Source document	The required setup for a source document is: Document type: D365 F&SCM Handler: BisMdmDocumentAxDatabase
Target document	The required additional setup for the target document is: On the document header: Document type: 'Staging' Journal type: Enter the name of the staging journal. Number sequence: Select the number sequence for the staging journal. Journal table: Select 'BisStagingBufferOrderJournal'. Usually, this journal table is used. On the document lines: For each record, in the Record table field, enter 'BisStagingBufferTable'.
Message	The required setup for a 'Data to staging' message is: On the message header, in the 'Update source status' section: Status field: MessageStatus Processed status: Processed Error status: Error On the message header, in the 'Custom' section: Handler: BisMdmMessageRunDirectV2

For more information on setting up connectors, documents, and messages, refer to Connectivity studio.

Related to	Notes
Set up MDM messages manually

Set up MDM message - Data to staging Application task